DSCP target


Home > Tutorial > DSCP target

DSCP target

This is a target that changes the DSCP(Differentiated Services Field) marks inside a packet. The DSCP target is able to set any DSCP value inside a TCP packet, which is a way of telling routers the priority of the packet in question. For more information about DSCP, look at the RFC 2474 - Definition of the Differentiated Services Field (DS Field) in the IPv4 and IPv6 Headers RFC document.

Basically, DSCP is a way of differentiating different services into separate categories, and based on this, give them different priority through the routers. This way, you can give interactive TCP sessions (such as telnet, SSH, POP3) a very high fast connection, that may not be very suitable for large bulk transfers. If on the other hand the connection is one of low importance (SMTP, or whatever you classify as low priority), you could send it over a large bulky network with worse latency than the other network, that is cheaper to utilize than the faster and lower latency connections.

Table 11-6. DSCP target options

Exampleiptables -t mangle -A FORWARD -p tcp --dport 80 -j DSCP --set-dscp 1
ExplanationThis sets the DSCP value to the specified value. The values can be set either via class, see below, or with the --set-dscp, which takes either an integer value, or a hex value.
Exampleiptables -t mangle -A FORWARD -p tcp --dport 80 -j DSCP --set-dscp-class EF
ExplanationThis sets the DSCP field according to a predefined DiffServ class. Some of the possible values are EF, BE and the CSxx and AFxx values available. You can find more information at Implementing Quality of Service Policies with DSCP site. Do note that the --set-dscp-class and --set-dscp commands are mutually exclusive, which means you can not use both of them in the same command!


Works under Linux kernel 2.3, 2.4, 2.5 and 2.6.